TM 11-5895-1096-40P
SECTION I
INTRODUCTION
1. Scope
This manual lists spares and repair parts; special tools;
which, because of probable discontinuance or
special test, measurement, and diagnostic equipment
shutdown of production facilities, would prove
(TMDE), and other special support equipment required
uneconomical to reproduce at a later time.
for performance of general support maintenance of the
XD -
A support item that is not stocked. When
TS-3566/GRA-114. It authorizes the requisitioning and
required, item will be procured through normal
issue of spares and repair parts as indicated by the
supply channels.
source and maintenance codes.
2. General
NOTE
This Repair Parts and Special Tools List is divided into
Cannibalization or salvage may be used as a source
the following sections:
of supply for any items source coded above except
a. Section II. Repair Parts List. A list of spares and
those coded XA and aircraft support items as
restricted by AR 750-1.
repair parts authorized for use in the performance of
(2) Maintenance code. Maintenance codes are
maintenance. The list also includes parts which must be
assigned to indicate the levels of maintenance
removed for replacement of the authorized parts. Parts
authorized to USE and REPAIR support items. The
lists are composed of functional groups in numeric
maintenance codes are entered in the third and fourth
sequence, with the parts in each group listed in figure
positions of the Uniform SMR Code format as follows:
and item number sequence.
b. Section III. Special Tools List. Not applicable.
(a) The maintenance code entered in the third
c. Section IV National Stock Number and Part
position will indicate the lowest maintenance level
Number Index. A list, in National item identification
authorized to remove, replace, and use the support item.
The maintenance code entered in the third position will
number (NIIN) sequence, of all National stock numbers
indicate one of the following levels of maintenance:
(NSN) appearing in the listings, followed by a list, in
alphanumeric sequence, of all part numbers appearing in
Code
Application/Explanation
the listings. National stock numbers and part numbers
O-
Support item is removed, replaced, used at the
are cross-referenced to each illustration figure and item
organizational level.
number appearance.
H-
Support item is removed, replaced, used at the
general support level.
3. Explanation of Columns
(b) The maintenance code entered in the fourth
position indicates whether the item is to be repaired and
a. Illustration. This column is divided as follows:
identifies the lowest maintenance level with the capability
(1) Figure number. Indicates the figure number
to perform complete repair (i.e., all authorized
of the illustration on which the item is shown.
maintenance functions). This position will contain one of
(2) Item number. The number used to identify
the following maintenance codes:
item called out in the illustration.
b. Source, Maintenance, and Recoverability (SMR)
Code
Application/Explanation
Codes.
H-
The lowest maintenance level capable of
(1) Source code. Source codes indicate the
complete repair of the support item is the
manner of acquiring support items for maintenance,
general support level.
repair, or overhaul of end items. Source codes are
Z-
Nonreparable. No repair is authorized.
entered in the first and second positions of the
(3) Recoverability code. Recoverability codes are
Uniform SMR Code format as follows:
assigned to support items to indicate the disposition
Code
Definition
action on unserviceable items. The recoverability code is
PA -
Item procured and stocked for anticipated or
entered in the fifth position of the Uniform SMR Code
known usage.
format as follows:
PG -
Item procured and stocked to provide for
sustained support for the life of the equipment. It
is applied to an item peculiar to the equipment
1
