TM 11-6625-842-24P
SECTION I
INTRODUCTION
Definition
Code
1. Scope.
This manual lists spares and repair parts; special tools;
only for subsequent or additional initial issues
special test, measurement, and diagnostic equipment
(TMDE), and other special support equipment required
ishment.
for performance of organizational, direct support, and
XD-A support item that is not stocked. When re-
general support maintenance of the AN/APM-239A.
quired, item will be procured through normal
It authorizes the requisitioning and issue of spares and
supply channels.
repair parts as indicated by the source and mainte-
NOTE
nance codes,
Cannibalization or salvage may be used as a
2. General
source of supply for any items source coded
This Repair Parts and Special Tools List is divided into
above except those coded XA and aircraft
the following sections:
support items as restricted by AR 700-42.
a. Section II. Repair Parts List. A list of spares and
(2) Maintenance code. Maintenance codes are as-
repair parts authorized for use in the performance of
signed to indicate the levels of maintenance authorized
maintenance. The list also includes parts which must
to USE and REPAIR support items. The maintenance
be removed for replacement of the authorized parts.
codes are entered in the third and fourth positions of
Parts lists are composed of functional groups in nu-
the Uniform SMR Code format as follows:
meric sequence, with the parts in each group listed in
figure and item number sequence.
position will indicate the lowest maintenance level au-
b. Section III. Special Tools List, Not applicable.
thorized to remove, replace, and use the support item.
c. Section IV. National Stock Number and Part
The maintenance code entered in the third position
Number Index. A list, in National item identification
will indicate one of the following levels of mainte
number (NUN) sequence, of all National stock num-
nance:
bers (NSN) appearing in the listings, followed by a list,
Code
ApplicatiouWExphnatum
in alphameric sequence, of all part numbers appearing
O-Support item is removed, replaced, used at the
in the listings. National stock numbers and part num-
organizational level.
bers are cross-referenced to each illustration figure
HSupport item is removed, replaced, used at the
and item number appearance.
general support level.
3. Explanation of Columns
a. Illustration. This column is divided as follows:
position indicates whether the item is to be repaired
(1) Figure number. Indicates the figure number of
and identifies the lowest maintenance level with the
the illustration on which the item is shown.
capability to perform complete repair (i.e., all author-
(2) Item number. The number used to identify
ized maintenance functions). This position will contain
item called out in the illustration.
one of the following maintenance codes:
Code
Application/Exptanation
b. Source, Maintenance, and Recoverability (SMR)
Codes.
HThe lowest maintenance level capable& complete
(1) Source code. Source codes indicate the manner
repair of the support item is the general support
of acquiring support items for maintenance, repair or
level.
overhaul of end items. Source codes are entered in the
ZNonreparable. No repair is authorized
first and second positions of the Uniform SMR Code
(3) Recoverability code. Recoverability codes are
format as follows:
assigned to support items to inidicate the disposition
Code
Definiton
action on unserviceable items. The recoverability code
PA Item procured and stocked for anticipated or
is entered in the fifth position of the Uniform SMR
known usage.
Code format as follows.
PD-Support item, excluding support equipment pro-
I