TM 11-6625-2632-14-1
(7) Tag wires at switch A1A1S1 (13). Unsolder
(3) Carefully peel off rubber channel (9).
wires. Remove nut (part of 13) and washer (part of
(4) Remove four screws (6) and carefully lift
13) and remove switch (13).
panel assembly A1 (8) out of case assembly A 2
(8) Tag wires at variable resistor A1A1R1 or
(10).
A1A1R2 (15). Unsolder wires. Remove locknut
(5) Tag and unsolder wire from feedthru
(part of 15) and remove variable resistor (15).
terminal A2A2E2 (4, fig. 5-5).
e. Removal of Shielded Box Assembly.
b. Removal of Cover Assembly and Parts (fig.
(1) Remove panel assembly (a above).
(2) Remove the bar (4, fig. 5-4) above the
(1) Remove panel assembly (a above).
shielded box assembly A2A2 (3).
(2) Remove two screws (12, fig. 5-1), rubber
( 3 ) Remove four screws (not called out)
bumpers (13) and hinge bar (11).
(3) Lift off cover assembly (14).
securing cover (not called out) of shielded box
(4) Remove instruction book holder (6, fig.
assembly A2A2 (3) and open cover.
( 4 ) Tag and unsolder wire from TRANS-
bumpers (9) and hinge (10).
MITTER connector A2J1 (19).
(5) Close cover of shielded box assembly
c. Removal of Meter A1M1.
(1) Remove panel assembly (a above).
A2A2. Secure cover with four screws removed in
(2) Tag wires and unscrew terminal nuts (not
(3) above. One screw also secures terminal lug (1).
illustrated) from meter A1M1 (3, fig. 5-3). Remove
(6) Remove four screws (18). Remove
terminal lugs (11) with capacitor A1A1C1 (12) and
TRANSMITTER connector A2J1 (19) with one
jack cap (10).
wires attached.
( 7 ) Tag and unsolder wire from feedthru
(3) Unscrew mounting ring (part of 3) and
remove meter (3) from panel.
terminal A2A2E2 (4, fig. 5-5).
d. Removal of Mounting Bracket Assembly and
(8) Remove shielded box assemble A2A2 (3,
Parts.
(1).
(1) Remove panel assembly (a above).
f. Removal of Mounting Plate Assembly.
(2) Tag wires and unscrew terminal nuts from
meter A1M1 (3, fig. 5-3). Remove terminal lugs
(1) Remove shielded box assembly (e above).
(11) with capacitor A1A1C1 (12) and wires at-
(2) Remove four screws securing cover of
tached.
shielded box assembly A2A2 (3, fig. 5-4) and open
cover.
( 3 ) Tag and unsolder wire from feedthru
terminal A2A2E2 (4, fig. 5-5).
( 3 ) Tag and unsolder wire from feedthru
(4) Loosen set screws and remove knob (5, fig.
terminal A2A2E1 (6, fig. 5-5).
(4) Remove two screws (7), washers (3), nuts
(2) and spacers (5).
(5) Remove two screws (2), washers (7),
(5) Remove mounting plate assembly (13).
spacers (6), nuts (8) and terminal lug (10).
(6) Remove mounting bracket assembly (9).
5-9
