TM 11-6625-2632-14-1
B-3. Column Entries
e. Column 5, Tools and Equipment. Column 5
a. Column 1, Group Number. Column 1 lists
specifies by code, those common tool sets (not
individual tools) and special tools, test, and
group numbers, the purpose of which is to identify
c o m p o n e n t s , assemblies, subassemblies, and
support equipment r e q u i r e d to perform the
modules with the next higher assembly.
designated function.
b. Column 2, Component/Assembly. Column 2
f. Column 6, Remarks. Column 6 contains an
contains the noun names of components, assem-
alphabetic code which leads to the remark in
blies, subassemblies, a n d modules for which
section IV, Remarks, which is pertinent to the
maintenance is authorized.
item opposite the particular code.
c. Column 3, Maintenance Functions. Column 3
B-4. Tool and Test Equipment Requirements (sect
lists the functions to be performed on the item
III)
listed in column 2. When items are listed without
a. Tool or Test Equipment Reference Code. The
maintenance functions, it is solely for purpose of
numbers in this column coincide with the numbers
having the group numbers in the MAC and RP-
used in the tools and equipment column of the
STL coincide.
MAC. The numbers indicate the applicable tool or
d. Column 4, Maintenance Category. Column 4
test equipment for the maintenance functions.
specifies, by the listing of a " worktime" figure in
b. Maintenance Category. The codes in this
the appropriate subcolumn(s), the lowest level of
column indicate the maintenance category allocated
maintenance authorized to perform the function
the tool or test equipment.
listed in column 3. This figure represents the
c. Nomenclature. This column lists the noun
active time required to perform that maintenance
name and nomenclature of the tools and test
function at the indicated category of maintenance.
equipment required to perform the maintenance
If the number or complexity of the tasks within
functions.
the listed maintenance function vary at different
d. National/NATO Stock Number. This column
maintenance categories, appropriate `` worktime"
l i s t s the National/NATO stock number of the
figures will be shown for each category. The
specific tool or test equipment.
number of task-hours specified by the `` worktime"
e. Tool Number. column lists the
figure represents the average time required to
manufacturer's part number of the tool followed by
restore an item (assembly, subassembly, com-
ponent, module, end item or system) to a ser-
t h e Federal Supply Code for manufacturers
conditions. This time includes preparation time,
(5-digit) in parentheses.
t r o u b l e s h o o t i n g time, and quality assuran-
B-5. Remarks (sect IV)
ce/quality
a. Reference Code. This code refers to the
ce/quality control time in addition to the time
appropriate item in section II, column 6.
required to perform the specific tasks identified for
b. Remarks. This column provides the required
t h e maintenance functions authorized in the
explanatory information necessary to clarify items
m a i n t e n a n c e allocation chart. Subcolumns of
appearing in section II.
column 4 are as follows:
COperator/Crew-Not applicable.
O -- O r g a n i z a t i o n a l -- A v i a t i o n Unit Main-
tenance (AVUM)
F--Direct Support/General Support in Aviation
Intermediate Maintenance (AVIM)
HNot applicable.
DDepot
(Next printed page is B-3)
B-2
