TM 11-6625-2709-12
f. Column 6, Remarks. Column 6 contains an
listed maintenance function vary at different
alphabetic code which leads to the remarks in
maintenance categories, appropriate "work time"
Section IV, Remarks, which is pertinent to the
figures will be shown for each category. The
item opposite the particular code.
number of task-hours specified by the "work time"
figure represents the average time required to
restore an item (assembly, subassembly, compo-
C-4. Tool and Test Equipment Requirements
nent, module, end item or system) to a serviceable
(Sec III)
condition under typical field operating conditions.
a. Tool or Test Equipment Reference Code. The
This time includes preparation time, trouble-
numbers in this column coincide with the numbers
shooting time, and quality assurance/quality con-
used in the tools and equipment column of the
trol time in addition to the time required to
MAC. The numbers indicate the applicable tool or
perform the specific tasks identified for the
test equipment for the maintenance functions.
maintenance functions authorized in the mainte-
b. Maintenance Category. The codes in this
nance allocation chart. Subcolumns of column 4
column indicate the maintenance category allo-
are as follows:
cated the tool or test equipment.
C -- Operator/Crew
c. Nomenclature. This column lists the noun
O -- Organizational
name and nomenclature of the tools and test
F -- Direct Support
equipment required to perform the maintenance
H -- General Support
functions.
D -- Depot
d. National/NATO Stock Number. This column
lists the National/NATO stock number of the
e. Column 5, Tools and Equipment. Column 5
specific tool or test equipment.
e. Tool Number. This column lists the manufac-
specifies by code, those common tool sets (not
individual tools) and special tools, test, and support
turer's part number of the tool followed by the
Federal Supply Code for manufacturers (5-digit) in
equipment required to perform the designated
parentheses.
function.
(Next printed page is C-3)
C-2
