TM 11-6625-2950-13
COMPONENTS OF END ITEM LIST
Section I. INTRODUCTION
B-1. Scope
c. Part Number. Iindicates the primary number
used by the manufacturer, which controls the design and
This appendix lists integral components of the basic
characteristics of the item by means of its engineering
issue items for the test set group to help you inventory
drawings, specifications, standards, and inspection re-
items required for safe and efficient operation.
quirements to identify an item or range of items.
d. Description. Indicates the Federal item name
B-2. General
and, if required, a minimum description to identify the
This Components of End Item List is divided into the
item.
e. L o c a t i o n . The physical location of each item
following sections:
a. Section II. Integral Components of the End
listed is given in this column. The lists are designed to
Item. These items, when assembled, comprise the test
inventory all items in one area of the major item before
set group and must accompany it whenever it is trans-
moving on to the adjacent area.
f. Usable on Code. "USABLE ON" codes are in-
ferred or turned in. The illustrations will help you identify
these items.
cluded to help you identify which component items are
b. Section III. Basic Issue Items. These are the
used on the different models. Identification of the codes
minimum essential items required to place the test set
used in these lists are:
group in operation, to operate it, and to perform
emergency repairs. Although shipped separately, packed
(EXAMPLE)
they must accompany the test set group during operation
Code
Used On
and whenever it is transferred between accountable
PAA
Model 114
officers. The illustrations will assist you with hard-to-
Model 114A
PAB
identify items. This manual is your authority to requisi-
PAC
Model 114B
tion replacement BII, based on TOE/MTOE authoriza-
g. Quantity Required (Qty Reqd). This column
tion of the end item.
lists the quantity of each item required for a complete
major item.
B-3. Explanation of Columns
h. Q u a n t i t y . This column is left blank for use
a. Illustration. This column is divided as follows:
during an inventory. Under the Rcv'd column, list the
(1) Figure Number. Indicates the figure number
quantity you actually receive on your major item. The
of the illustration on which the item is shown.
date columns are for your use when you inventory the
(2) Item Number. The number used to identify
major item at a later date; such as for shipment to another
item called out in the illustration.
site.
b. National Stock Number. Indicates the National
stock number assigned to the item and which will be used
for requisitioning.
