Code
Used on
c. Description. Indicates the Federal item name
A7U
AN/ARM-71
and a minimum description required to identify the item.
b. The following publication pertains to the
The last line indicates the reference number followed by
the applicable Federal Supply Code for Manufacturer
AN/ARM-71 and its components:
(FSCM) in parentheses. The FSCM is used as an
TM 11-6625583-12
Operator and Organizational
element in item identification to designate manufacturer
Maintenance Manual: Test
or distributor or Government agency, etc., and is
Set, Receiver, Radio AN/
identified in SB 70842.
ARM-71.
d. Unit of Measure (U/M). Indicates the standard
1-5. Location of Repair Parts
or basic quantity by which the listed item is used in
performing the actual maintenance function.
This
a. This manual contains one cross-reference index
measure is expressed by a two-character alphabetical
abbreviation; e.g., ea, in, pr, etc., and is the basis used
Federal stock number or reference number
to indicate quantities and allowances in subsequent
(manufacturer's part number) is known.
The first
columns. When the unit of measure differs from the
column in the index is prepared in numerical or
unit of issue, the lowest unit of issue that will satisfy the
alphanumeric sequence in ascending order.
The
required units of measure will be requisitioned.
reference numbers (manufacturer's part numbers) are
e. Quantity Incorporated in Unit. This column
listed immediately following the last listed Federal stock
indicates the quantity of the item used in the equipment.
number in the index of Federal stock numbers.
Subsequent appearances of the same item in the same
b. When the Federal stock number or reference
assembly are indicated by the letters "REF".
number is known, follow the procedures given in (1) and
f. 15-Day Organizational Maintenance Allowance.
(2) below.
(1) The repair parts indicated by an asterisk
(1) Refer to the index of Federal stock
in the allowance column represent those authorized for
numbers (sec V) and locate the Federal stock number or
use at the organizational category, and will be
reference number. The FSN and reference number are
requisitioned on an "as required" basis, until stockage is
cross-referenced to the applicable figure and item
based on demand in accordance with AR 710-2.
number or reference designation.
(2) Major Army commanders are authorized
(2) Refer to the repair parts list (sec III) and
to approve reduction in the range of support items
locate the figure number (col 7a) and item number or
authorized for use in units within their commands.
reference designation (col 7b) as noted in the FSN
Recommendations for increase in range of items
index.
authorized for use will be forwarded to Commander, US
c. When the figure and item number or reference
Army Electronics Command, ATTN: AMSELMA-AN,
designation are known, scrutinize columns 7a and 7b of
Fort Monmouth, NJ, 07703. Any changes approved will
the repair parts list (sec III) until the item is located.
be reflected in a revision to the RPSTL.
d. When the FSN, reference number, figure
(3) Allowance quantities are indicated in the
number, item number and reference designation are not
special tools list section for special tools, TMDE, and
known, scrutinize column 3 of the repair parts list (sec
other equipment.
g. lllustration. This column is divided as follows:
(1) Figure number.
Indicates the figure
1-6. Abbreviations
number of the illustration on which the item is shown in
Not applicable.
TM 11-6625583-12.
(2) Item number. Indicates the item number
1-7.
Reporting of Equipment Publication
or reference designation used to reference the item in
Improvements
the illustration.
The
reporting
of
errors,
omissions,
and
recommendations for improving this publication by the
1-4. Special Information
individual user is encouraged. Reports should be
a. Usable on codes are included in column 3.
submitted on DA Form 2028 (Recommended Changes
Uncoded items are applicable to all models.
to Publications and Blank Forms) and forwarded direct
Identification of the usable on codes used in this
to Commander, US Army, Electronics Command,
publication are -
ATTN: AMSEL-MA-AN, Fort Monmouth, NJ 07703.
(Next printed page is 6)
4
