C 2, TM 11-6625-820-12
APPENDIX C
ORGANIZATIONAL
REPAIR
PARTS
Section I. INTRODUCTION
gory of maintenance authorized to install the
C-1. Scope
listed item is noted here.
This appendix contains a list of repair parts re-
Explanation
Code
quired for the performance of organizational main-
Organizational
Maintenance
O
tenance
for
TEST
SET,
RADIO
AN/ARM-92.
(3) Recoverability code (R). Not used.
Note. No
special
tools,
test,
and
support
equipment
are
Note.
When
no
code
is
indicated
in
the
recoverability
required.
column, the part will be considered expendable.
b. Federal Stock Number Column. The Federal
stock number for the item is listed in this column.
C2. General
c. Description Column. This column includes the
The repair parts list is divided into the following
Federal item name and any additional description
sections.
of the item required, the manufacturer's part
a. Prescribed Load Allowance (PLA), Section II.
n u m b e r (reference number), and the applicable
The PLA is a consolidated listing of repair parts
five-digit Federal Supply Code for Manufacturers
allocated for initial stockage at the organizational
(para C-5). Usable on code column is not used.
maintenance category. This is a mandatory mini-
d. Unit of Measure Column. The unit used as a
m u m stockage allowance.
basis of measure (e.g., ea, pr, ft, yd, etc.) is indi-
b. Repair Parts for Organizational
Maintenance,
cated in this column.
S e c t i o n III. R e p a i r p a r t s a u t h o r i z e d f o r o r g a -
e. Quantity Incorporated in Unit Column. T h e
nizational maintenance are included in this section.
quantity of repair parts in an assembly is given
Note. All indexes noted below are cross referenced to index
in this column.
numbers. The index numbers appear in ascending sequence
f. Maintenance Allowances Column.
in column 1 of the repair parts list (para 3a). T h e
index
(1) The maintenance columns are divided
number
for
the
particular
item
will
be
the
same
for
the
i n t o subcolumns. Indicated in each subcolumn is
item in all sections of this appendix.
the total quantity of items authorized for the
d. Reference Designation Cross Reference to Index
Number, Section V. This is a cross reference index
n u m b e r of equipments supported. Items author-
ized for use as required, but not for initial stockage,
of reference
and/or
item
numbers
to
index
numbers.
a r e identified with an asterisk (*) in the allow-
ance column.
( 2 ) The quantitative allowances for organi-
C-3.
Explanation
of
Columns
z a t i o n a l category of maintenance represents one
initial prescribed load for a 15-day period for the
A n explanation of the columns is given below.
number of equipments supported. Units and orga-
a.
Source, Maintenance, and Recoverability Codes
n i z a t i o n s authorized additional prescribed loads
( S M R ) and Index Number Column. The first line
will multiply the number of prescribed loads au-
in this column lists the applicable SMR codes for
thorized by the quantity of repair parts reflected
the part. Listed in ascending order directly below
in the appropriate
density column to obtain the
t h e SMR codes is the index number assigned to
total quantity of repair parts authorized.
the repair part.
(3) Subsequent changes to organizational al-
(1) S o u r c e c o d e s . T h e s e l e c t i o n s t a t u s a n d
lowances will be limited as follows: No change in
s o u r c e for the listed item is noted here. Source
the range of items is authorized. If additional
code and its explanation is as follows:
Explanation
Code
i t e m s are considered necessary, recommendation
P
-
Applies
to
repair
parts
that
are
stocked
in
or
sup-
should be forwarded to Commanding General,
plied from the GSA/DSA, or Army supply system,
U.S. Army Electronics Command, ATTN:
and
authorized
for
use
at
indicated
maintenance
AMSEL-ME-NMP-AN, Fort Monmouth, N.J.
categories.
07703, for exception or revision to the allowance
(2) Maintenance code (M). The lowest cate-
C-1
