TM 32-5811-025-14&P
Table 3-1. RF Processor Test Set Controls, Indicators,
and Connectors - Continued
Control, indicator, or connector
Function
VERIFICATION TEST-TEST SELECT
Position 3 - Causes the RF processor test
(rotary switch) (cont)
set to adjust the delay line setting of
the RF processor to 255 bits. The RF
processor selects the 255-bit delay line
offset in the RF processor test set. The
MODULATION switch of the RF processor is
set HIGH, and the df and intercept ampli-
fiers are inserted.
Position 4 - same as position 3 except
that the RF processor MODULATION switch
is set LOW.
Position 5 - Causes the RF processor test
set to adjust the delay line setting of
the RF processor to 128 bits. The RF
processor selects the 128-bit delay line
offset in the RF processor test set. The
MODULATION switch of the RF processor is
set HIGH, and the df and intercept ampli-
fiers are inserted.
Position 6 - Same as position 5 except
that the MODULATION switch is set LOW.
Position 7 - Same as position 5 except
that the df and intercept amplifiers in
the RF processor are bypassed.
Position 8 - Same as position 5 except
that the df and intercept amplifiers
are bypassed and the MODULATION switch
is set LOW.
AC
In - Indicates ac power is applied to the
(circuit breaker)
power supplies of the test set.
Out - Indicates ac power has been dis-
connected from the power supplies due to
an overload condition. The power may be
reset by pressing the button to the in
position.
OUT
J1 thru J4
Routes RF signal outputs to the unit
under test.
J5
Develops RF signal input for routing to
the unit under test.
3-4
