TM 11-4662S-2632-14
1-3.
Destruction of Army Materiel to Prevent Enemy
Radio Test Set AN/PRM-32 is simple to use but must be
Use
properly calibrated. Calibration is performed at general
support maintenance, as prescribed in TB 750-236.
Requirements for destruction will be those prescribed in
TM 750-244-2.
1-6.
Reporting of Equipment Publication
Improvements
1-4. Administrative Storage
The
reporting
of
errors,
omissions,
and
Requirements and procedures for administrative storage
recommendations for improving this publication by the
will be those prescribed in TM 740-90-1.
individual user is encouraged.
Reports should be
submitted on DA Form 2028 (Recommended Changes
to Publications) and forwarded direct to Commander,
U.S. Army Electronics Command, ATTN: AMSEL-MA-
AC, Fort Monmouth, NJ 07703.
Section II. DESCRIPTION AND DATA
1-7. Purpose and Use
Radio Test Set AN/PRM-32 is the primary piece of test
serves as a fully-shielded test path between the two
equipment used to check out Radio Set AN/PRC-90 at
organizational maintenance.
Two cable assemblies
during testing. Indications on the meter of the test set
(transmitter cable and receiver cable) (fig. 1-2) are
show the operating condition of the radio sets under test.
provided for attachment of the test set to the radio sets
being tested. One radio set under test serves as a
Figure 1-2. Radio Test Set AN/PRM-32 with cover open
1-2