TM 11-6625-2632-14
CHAPTER 2
OPERATING INSTRUCTIONS
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
2-1. General
see if the shipment is complete.
Report all
discrepancies in accordance with the instructions of TM
Radio Test Set AN/PRM-32 is packaged for shipment in
38-750. The equipment should be placed in service
a standard moisture-proof container. It requires no
even though a minor assembly or part that does not
special treatment upon receipt except removal by the
affect proper functioning is missing.
operator from the package. There are no special siting
c. Check to see whether the equipment has been
or shelter requirements to be considered. It is available
modified. (Equipment which has been modified will have
for use at any time. It should be used in a location as
the MWO number on the identification plate on the top of
free from moisture, mud, dirt, and snow as possible, but
the cover.) Check also to see whether all currently
can be used under such conditions if necessary.
applicable MWO's have been applied. (Current MWO's
applicable to the equipment are listed in DA Pam 310-7.)
2-2. Checking Unpacked Equipment
2-3. Installation Instructions
a. Inspect the equipment for damage incurred
during shipment. If the equipment has been damaged,
There are no installation requirements for Radio Test Set
report the damage in accordance with instructions in TM
AN/PRM-32.
No preliminary adjustments, external
38-750.
connections, or circuit alignment are required.
b. Check the equipment against the component
listing in the operator's manual and the packing slip to
Section II. CONTROLS AND INSTRUMENTS
2-4. General
Table 2-1. Radio Test Set AN/PRM-32
Controls and Indicators
There are no control settings on Radio Test Set
AN/PRM-32. It serves as a link in testing.
Control or
Indicator
Function
2-5. Operator's Controls
Transmitter cable ..........Connects test set to antenna
jack of transmitting radio
Operator's controls and indicators on Radio Test Set
under test.
AN/PRM-32 are identified in table 2-1 and shown in
Receiver cable ..............Connects test set to antenna
jack of receiving radio under
of the Radio Set AN/PRC-90 controls and indicators.
test.
Meter ...........................Indicates
power
level
of
transmitted radio signal.
Section III. OPERATION UNDER USUAL CONDITIONS
2-6. Introduction
signal from a second set. The usual procedure for
testing is to connect two radio sets to the test set and
Radio Test Set AN/PRM-32 was designed specifically to
test them both as transmitters and receivers in one set of
test Radio Set AN/PRC-90. It can test a single set for
test procedures. In this procedure the
transmission, or test one set for receiving the transmitted
2-1
