TM 11-6625-2718-14&P
OPERATOR'S, ORGANIZATIONAL, DIRECT SUPPORT,
AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS
AND SPECIAL TOOLS LIST
Section I. INTRODUCTION
B-1. Scope
b. Source, Maintenance, and Recoverability
Codes (SMR).
This appendix lists repair parts required for
(1) Source code. Source codes are assigned to
operation and performance of organizational and
support items to indicate the manner of acquiring
general support maintenance of the AN/URM-
s u p p o r t items f o r maintenance, repair, or
182.
overhaul of end items. Source codes are entered in
B-2. General
the first and second positions of the Uniform
This Basic Issue Items, Items Troop Installed or
SMR Code format as follows:
Authorized, Repair Parts and Special Tools List
Code
Definition
is divided into the following sections:
XD
a. Section II. Basic Issue Items List. N o t
A support item that is not stocked. When
required, item will be procured through normal
applicable.
supply channels.
b . Section III. Items Troop Installed or
Authorized List. Not applicable.
NOTE
c. Section IV. Repair Parts List. A list of repair
Cannibalization or salvage may be used
parts authorized for use in the performance of
as a source of supply for any items source
maintenance. The list also includes parts which
coded above except those coded XA, XD,
m u s t be removed for replacement of the
and aircraft support items as restricted
authorized parts.
by AR 700-42.
d. Section V. Special Tools List. Not ap-
plicable.
(2) Maintenance code. Maintenance codes are
e. Section VI. Federal Stock Number and Part
assigned to indicate the levels of maintenance
Number Index. A list, in ascending numerical
authorized to USE and REPAIR support items.
sequence, of all Federal stock numbers appearing
The maintenance codes are entered in the third
in the listings, followed by a list, in alphanumeric
and fourth positions of the Uniform SMR Code
sequence, of all part numbers appearing in the
format as follows:
listings. Federal stock numbers and part numbers
(a) The maintenance code entered in the
are cross-referenced to each illustration figure and
third position will indicate the lowest main-
item number appearance. This index is followed
tenance level authorized to remove, replace, and
by a cross-reference list of reference designations
use the support item. The maintenance code
to figure and item numbers when applicable.
entered in the third position will indicate one of
the following levels of maintenance:
B-3. Explanation of Columns
Code
Application/
Explanation
The following provides an explanation of columns
found in the tabular listings:
Support item is removed; replaced, used at the
O
a. Illustration. This column is divided as
organizational level.
follows:
Support item is removed, replaced, used at the
H
general support level.
(1) Figure number. Indicates the figure
number of the illustration in which the item is
shown.
(b) The maintenance code entered in the
(2) Item number. T h e n u m b e r u s e d t o
fourth position indicates whether the item is to be
identify each item called out in the illustration.
