TM
11-6625-622-12
OPERATION
Section 1. SERVICE UPON RECEIPT OF EQUIPMENT
(6) Remove the cables and cable adapters
2-1. Unpacking
from their storage space.
a. Packaging Data. All components of the
t e s t harness are in the transit case. When
2-2. Checking Unpacked Equipment
packed for shipment, the air vent on the transit
case is opened, and the test harness is on four
a. Inspect the equipment for damage incurred
polystyrene corner blocks that are in the four
during shipment. If the equipment has been
bottom corners of a tri-wall fiberboard box.
damaged, refer to paragraph 13b.
Four more corner blocks are on the top four
b. Check the equipment against the packing
corners of the test harness. The box is closed
list. When no packing list accompanies the
and taped shut. The box is 26 by 23 by 22
equipment, check the equipment against the
inches, the corner blocks are 6 by 6 by 6 inches
list of equipment supplied (para 16) and re-
with cutouts of 4 by 4 by 4 inches, the total
port any overages or shortages on DD Form 6
weight is 45 pounds, and the volume is 7.6 cubic
(para 1-3b).
feet, A typical shipping box and its contents
Note: Shortages of minor assemblies or subassemblies
are shown in figure 2-1.
such as lamps or fuses that do not affect the proper
b. Removing Contents.
functioning of the equipment should not prevent use of
(1) Use a knife to cut the tape on the box.
the equipment.
Open the four flaps.
c. If the equipment has been used or recon-
(2) Remove the four corner blocks from
ditioned, see whether it has been changed by a
the top of the box. Remove the test
modification work order (MWO). If the equip-
harness from the box.
ment has been modified, the MWO number will
(3) Disengage the four twistlock clamps
appear on the front panel near the nomencla-
and open the transit case.
ture plate. Check to see whether the MWO
number and appropriate notations concerning
(4) Remove the technical manuals from
the modification have been entered in this
their compartment.
manual.
(5) Unlock the access door by turning the
two quarter-turn fasteners. Lift the
Note: Current MWO's applicable to the equipment
door open.
are listed in DA Pamphlet 310-4.
