Section V
T.O. 33A1-3-358-11/TM 11-6625-842-15
Paragraphs 5-1 to 5-17
NAVAIR 16-30APM239-2
SECTION V
PARTS LIST
INTRODUCTION.
5-1.
This Parts List lists, describes and illustrates the assemblies, subassemblies and detail parts that
5-2.
comprise the Test Set, Transponder Set AN/APM-239A. This equipment is manufactured by Hazeltine
Corporation, Little Neck, New York, under contract number F33657-67-C-1319. This Parts List is for
Air Force and Navy use only. For Army use refer to TM 11-6625-842-25P.
The Parts List is arranged in the following three groups: INTRODUCTION, ILLUSTRATIONS AND
5-3.
PARTS LISTING, and NUMERICAL INDEX
ILLUSTRATIONS.
5-4.
The illustrations are arranged consecutively by figure number and carry the same caption as their
5-5.
accompanying listing. Each assembly is illustrated to a degree necessary to identify its detail parts.
5-6.
PARTS LISTING.
The Parts Listing is arranged in four columns as follows: SECTION, FIGURE AND INDEX NO
5-7.
PART NO., DESCRIPTION, and USABLE ON CODE.
5-8.
The SECTION AND INDEX NO. column lists the section in the handbook, the figure number of the
illustration, and the index number of the parts shown in the illustration.
5-9.
The PART NO. column lists the manufacturer's part number or the government standard part number.
When the Latter is used, the DESCRIPTION column cites the applicable controlling government agency code.
5-10. The DESCRIPTION column lists the name of the part with applicable modifiers and any additional in-
formation necessary to identify the part. Each detail part or subassembly is indented to indicate the relation-
ship to its next higher assembly. For vendor parts, the vendor's code, in accordance with Federal Supply
Code for Manufacturers H4-1, will be found in this column enclosed in parentheses, followed by the contrac-
tor's part number also enclosed in parenthesis. Vendor Codes for government standard parts are also listed
in the Description Column. When a vendor's code is not listed Hazeltine is the manufacturer of the part.
Explanation of Vendors' Codes will be found in paragraph 5-33.
5-11. The USABLE ON CODE column contains suitable coding for assemblies and parts to indicate specific
usability to its next higher assembly. Where no USABLE ON CODE appears, the part is applicable to all
assemblies.
5-12. NUMERICAL INDEX.
5-13. The Numerical Index, which immediately follows the parts listing, includes parts shown in the Part
Number Column of the Parts Listing cross referenced to the Provisioning Codes assigned by the Air Force
and Navy.
5-14. PROVISIONING CODES.
5-15. GENERAL. Provisioning codes assigned by the Air Force and Navy representatives are shown in the
Air Force Source Code and Repair Code columns, and in the Navy Source Code and Recoverability Code
columns of the Numerical Index.
5-16. AIR FORCE SOURCE CODES AND DEFINITIONS.
"P" SERIES - PARTS PROCURED AND UNDER INVENTORY STOCK CONTROL.
5-17.
Code "P" identifies parts which may be requisitioned and installed by any level of maintenance
a.
consistent with the activity's authorized scope of maintenance. Code "P" is applied to parts on which usage
is anticipated or known. Restricted (emergency) service manufacture of code "P" items is considered practi-
cal but may be accomplished only after confirmation of non-availability from supply sources.
5-1
