TM 11 5895-1096-40
the equipment as shown in the applicable hookup diagram and
3-5. Continuity Measurements.
perform the procedures in the applicable test table in the order
given.
Routine continuity checks between various points of circuitry
can be made using Multimeter AN/USM-223, or equivalent,
b. Main Assembly Bench Test. Hookup the equipment
as shown in figure 3-3. Set the controls as shown in table 3-1.
Follow the procedures in table 3-2 to determine the proper
3-6. Bench Tests.
operation of the test set main assembly.
a. General.
To perform the bench tests, hookup
Figure 3-3. Main assembly Bench Test Hookup.
c. Probe Amplifier Bench Test. Remove the probe from
Follow the procedures in table 3-4 to determine the proper
operation of the probe amplifier assembly.
he probe amplifier and hookup the equipment as shown in
3-6
