TM 11-6625-2632-14-1
equipment from equipment in use. Conspicuously
6. The maintenance allocation chart (MAC)
mark the area "Administrative Storage. "
appears in appendix B; the repair parts list is
b. Maintenance Services. Before the Radio Test
contained in TM 11-6625-2632-24P-1.
S e t AN/PRM-32A is placed in administrative
storage, perform the procedures in table 3-1 of this
a DA Pam 310-4. Refer to the latest issue of
manual. Faulty equipment should not be placed in
DA Pam 3104 to determine whether there are new
storage. If equipment fails test, troubleshoot using
edit ions, changes, or additional publications pert-
the procedures in paragraph 5-6 of this manual.
aining to the equipment.
Further, clean the equipment so that it is free of
b. DA Pam 310-7. Refer to DA Pam 310-7 to
dirt, grease, and other contaminants using the
determine whether there are modification work
p r o c e d u r e s in paragraph 3-7 of this manual.
orders (MWO's) pertaining to the equipment.
Remove dust and damaged paint by scraping, wire
brushing, sanding or buffing. Sand to a smooth
a. Reports of Maintenance and Unsatisfactory
f i n i s h and spot paint as `necessary. See TB
E q u i p m e n t . Maintenance forms, records and
43-0118.
reports which are to be used by maintenance
c. Removal from storage. When the Radio Test
personnel at all maintenance levels are listed in
Set AN/PRM-32A is removed from storage, it
and prescribed by TM 38-750.
m u s t be tested to insure that it is operating
b. Report of Packaging and Handling Deficien-
satisfactorily for use in the field. Test it by using
ties. Fill out and forward DD Form 6 (Packaging
the procedures in table 3-1 of this manual.
I m p r o v e m e n t Report) as prescribed in AR
1-6. Calibration.
700-58/NAVSUPINST
4030.29/AFR
71-13/MCO
Radio Test Set AN/PRM-32A is simple to use but
P4030.29A, and DLAR 4154.8.
must be properly calibrated. Calibration is per-
c. Discrepancy in Shipment Report (DISREP)
f o r m e d at general support maintenance, as
(SF 361). Fill out and forward Discrepancy in
prescribed in TB 43-180.
shipment Report (DISREP) (SF 361) as prescribed
in
AR
55-38/NAVSUPINST
4610.33B/AFR
mendations (EIR)
75-18/MCO P4610.19C and DLAR 4500.15.
EIR's will be prepared using Standard Form 368
( Q u a l i t y Deficiency Report). Instructions for
Enemy Use.
preparing EIR's are provided in TM 38-750, The
Requirements f o r destruction will be those
Army Maintenance Management System. EIR's
prescribed in TM 750-244-2.
should be mailed directly to Commander, U.S.
Army Communications and Electronics Materiel
a. General. Electronics equipment that is placed
R e a d i n e s s Command, ATTN: DRSEL-ME-MQ,
in administrative storage should be capable of
Fort Monmouth, NJ 07703. A reply will be fur-
being ready for use within a 24-hour period. Select
nished directly to you.
the best available site for storage. Separate stored
DESCRIPTION
AND
DATA
Section II.
1-9. Description
Radio Test Set AN/PRM -32A is the primary piece
of test equipment used to check out Radio Set
Radio Test Set AN/PRM 32A is a self-contained
A N / P R C - 9 0 and Radio Set AN/PRC-106 (the
unit built into an aluminum case and hinged cover.
A N / P R C - 1 0 6 is not in Army inventory at this
The cover is used to store the two cable assemblies
(a below), two connector adapters (b below), a
time) at organizational maintenance. Two cable
assemblies and two Adapters, Test
wrench used to remove the antennas from radio
MX-8802/PRC-90 ( c o n n e c t o r a d a p t e r s ) a r e
sets under test and an instruction book. The cover
is secured with an elbow catch when the test set is
provided for attachment of the test set to the radio
sets being tested. One radio set under test serves
not in use. Two BNC connectors, one on each side
as a transmitter and the other as a receiver. The
of the test set, are provided to connect the test set
test set seines as a fully-shielded test path bet-
to the radio sets under test. Two jack caps are
ween the two radios. Ther is no interference with
attached to the case to seal the connectors from
operating channels during testing. Indications on
dirt and moisture when they are not being used.
the meter of the test set show the operating
The test set is self-contained and requires no
condition of the radio sets under test.
batteries or other power source. It is made ready
