+19.00 and +21.80.
changes in the "Performance Standard" column.
In step 4b, change " + 1 0 . 5 0 " to: between
In step 2b, change "+14.2" to: between
+9.90 and +1120.
+13.40 and +15.00.
In step 4c, change " + 1 3 . 0 0 " to: between
In step 2c, change "+17.6" to: between
+12.70 and +14.20.
+17.30 and +19.50.
Add step No. 5 after step No. 4.
In step 3b, change "+20.7" to: between
Equipment under
Test
Performance
test control
Test equipment
standard
procedure
settings
Step No.
control settings
a RED indicator
a. Same as step
Same as step No. 1
5
Sane as step No. 4
lights.
No. 4a.
except: Selector
switch: 19
b. TS-443/U indi-
b. Same as step
No. 4b.
cdes between-
+13.00 and
+14.70 volts.
In step No. lc, change "0.180" to: between
Page 43, paragraph 48c. Make the following
.125 and .250.
changes:
In step No. 2c, change "0.220" to: between
Add the following after the heading of sub-
.200 and .250.
p a r a g r a p h c: The light indication change to
GREEN may occur instantaneously, but if it
In step No. 3c, change "0.480" to: between
does not the change should occur within 10 sec-
.170 and 210.
nds after required voltage limits are applied to
the test probe.
In step No. 4c, change "0.720" to: between
.650 and .810.
Make the following changes in the "Per-
fomance Standard" column:
Page 51, paragraph 50c. Make the following
In step lb, change "2.85" to: between 2.60
changes in the "Performance standard" column:
and 3.30.
In step No. lb, change "0.27" to: between
In step 2b, change "U3" to: between 1250
0230 and .330.
and 14.90.
In step No. 2b, change "0.130" to: between
In step 3b, change "0.49" to: between .450
.100 and .140.
and .520.
In step No. 3b, change "0.225" to: between
In step 4b, change `0.90" to: between .800
.180 and .250.
and 1.00.
In step No. 4b, change "0.014" to: between
In step 5b, change "0.225" to: between .200
.012 and .016.
and .250.
In step 6b, change "6.40" to: between 6.00
Page 53, paragraph 51c. In "Performance stand-
and 7.30.
ard" column, change subparagraph b to read:
411A indicates between .100 and .135 volt.
Page 47, paragraph 49c. Make the following
Page 54, paragraph 52, chart. Delete the chart
changes in the "Performance standard" column:
and substitute:
7
