Caution: check to be sure that signal voltages
ME-30B/U and ME-30
are removed from the brfore setting the
C/U.
TS-1777/VRM-1 ON-OFF switch to OFF.
TM 11-6625-
O p e r a t o r ' s and Organizational
e. Remove all test connections and turn the
392-12
Maintenance Manual: Test
power off.
Set, Transponder Set AN/
Page 69. Add to the appendix:
URM-125.
Depot Inspection Standard for
TM 11-6625-
TB SIG 355-1
436-10
Electronic AN/USM-98.
Repaired Signal Equipment.
Depot Inspection Standard for
Page 77, figure 39 (as changed by C 1, 13 Jan-
TB SIG 355-2
uary 1964). Make the following changes:
Refinishing Repaired signal
Add to the notes:
Equipment.
6. R7918 (22 OHMS) IS CONNECTED BE-
TM 11-2649
TWEEN THE PROBE RF OUTPUT AND
(Hewlett-Packard Model 205
THE INPUT OF FL7501.
-AG).
Change the type number of Q7601 from
TM 11-5057
"2N502" to: 2N502B.
26.
Change the type number of Q7702 from
Operator and Organizational
TM 11-6625 -
"2N502A" to: 2N502B.
Maintenance Manual: Mul-
200-12
Change the values of the following resistors:
t i m e t e r s ME-26A/U and
R7707. From "1,800" to: 5.6K.
ME-26B/U.
R7914. From "220" to: 402.
Operator's and Organizational
TM 11-6625-
R7913. From "113" to: 66.5.
320-l2
Maintenance Manual: Volt-
R7911. From "22.1" to: 84.5.
m e t e r , Meter ME-30A/U
10