TM 11-6625-820-12
OPERATION
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
Unpacking
(5)
Remove the aid box from its storage
compartment in the lid of the carrying
All components of the test
a. Packaging Data.
case.
set are contained in the carrying case. W h e n
(6) Open the storage compartment lid and
packed for shipment the air vent, on the carrying
and take the pendant cables from their
case is opened.
The carrying case is placed on
storage
compartment.
four polystyrene corner blocks that are in the four
Checking Unpacked Equipment
bottom
corners
of
a
triple-wall
fiberboard
box.
a. Inspect
the
equipment
for damage in-
Four more corner blocks are then placed on the
If the equipment
curred during shipment.
top four corners of the carrying case. The box is
has been damaged, refer
to
then closed and taped shut. The box is 25 x 22x
b. Check
the
equipment
against
the
pack-
18 inches, the corner blocks are 6 x 6 x 6 inches
ing list.
If
no
packing
list
accompanies
the
with cutouts 4 x 4 x 4 inches. The total weight
equipment, check the equipment against the
of the box is 43 pounds, and the volume is 5.7
list of equipment supplied (para 1-6 or
cubic
feet.
A
typical
shipping
box
and
its
1-6.1)
and
report
any
overages
or
components are shown in figure 21.
shortages on DD Form 6 (para 1-3b).
b. Removing contents.
c. I f t h e e q u i p m e n t h a s b e e n u s e d o r r e c o n d i -
(1) U s e a k n i f e t o c u t t h e t a p e o n t h e b o x .
tioned, see whether it has been changed by a
Open the four flaps.
modification work order (MWO). If modified,
(2) R e m o v e t h e f o u r c o r n e r b l o c k s f r o m t h e
an MWO number will appear on the front panel
top of the carrying case. Remove the
near
the
nomenclature
plate.
Check
to
see
carrying case from the box.
whether the MWO number and the appropriate
(3) D i s e n g a g e t h e t w o t w i s t - l o c k c l a m p s a n d
notations concerning the modification have been
open the carrying case.
entered in this manual.
(4) R e m o v e t h e t e c h n i c a l m a n u a l f r o m t h e
Note.
Current
MWO's
applicable
to
the
equipment
are
lid of the carrying case.
listed
in
DA
Pam
3104.
Section Il. OPERATING INSTRUCTIONS
Controls, Indicators, and Connectors
in a t h r o u g h e below
The
charts
list
and
indicate the functions of the controls, indica-
tors, and connectors.
2-2.1 illustrate the test set front panel (with
the control unit, OBS indicator, and
RMI)
controls, indicators, and connectors.
a. Test Set.
