TM 11-6625-2709-40
g. Replacement of RMI.
(2) Replace control unit in front panel.
(3) Tighten the four Dzus fasteners.
(1) Connect P4 to RMI connector.
l. Replacement of Front Panel.
(2) Replace RMI in front panel.
(1) Connect power cable to J5.
(3) Replace the four screws, to hold RMI to
front panel.
(2) Place front panel back in lower carrying
case. Be sure no cables are pinched between chassis
(4) Replace test set front panel (step (1) below).
and carrying case.
h. Reassembly and Lubrication of OBS Indicator.
(3) Replace the 7 screws in perimeter of front
Refer to TM 11-5826-226-34 for reassembly and
panel.
l u b r i c a t i o n procedures for Course Indicator ID-
1347C/ARN-82.
i. Replacement of OBS Indicator.
Wiring Harness TS-2501/ARM-92.
(1) Connect P6 to OBS connector.
Remove bottom panel of aid box as follows:
(2) Replace OBS indicator in front panel.
a. Remove the six screws that hold bottom panel in
place.
(3) Replace the four screws, to hold OBS in-
dicator to front panel.
b. Lift bottom panel away.
(4) Replace test set front panel (step (1) below).
3-6. Reassembly Techniques for Aircraft Test Set
Wiring Harness TS-2501/ARM-92.
j. Reassembly and Lubrication of Control Unit.
Refer to TM 11-5826-226-34 for reassembly and
Replace bottom panel of aid box as follows:
lubrication procedures for Radio Set Control C-
6873B/ARN-82.
a. Place bottom panel on aid box.
k. Replacement of Control Unit.
b. Replace the six screws, to hold bottom panel in
place.
(1) Connect P5 to control unit connector.
Change 1
