TM 11-6625-2718-14&P
NOTE
higher than 100 watts. Use it only to test
If an antenna is not available during
rf power in the 30 to 76 MHz frequency
performance of the test, use a dummy
range.
load (Dummy Load, Electrical DA-75/U,
b. Position the TS-2069A/U so that the groove
or equivalent) in its place.
in the clamping block engages the rack handle
CAUTION
attached to the transmitter front panel as shown
Although the TS-2609A/U is ruggedly
in figure 2-2. Choose the rack handle, left or right,
constructed, unnecessarily rough hand-
t h a t permits the Cable Assembly, RF CG-
ling, dropping, or severe impact can
409G/U to interconnect the antenna rf output
damage the delicate mechanism of the
j a c k on the transmitter and the transmitter
meter. Be careful when handling the TS-
connector on the test set. Tighten the thumb-
2609A/U. Do not use the TS-2609A/U to
screw on the clamping block to secure the TS-
2609A/U to the rack handle.
test equipment which has a power output
