TM 11-6625-2718-14&P
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. TOOLS AND EQUIPMENT
4-1. Special Tools and Test Equipment
You will require no special tools or special test
Repair parts available for use at organizational
equipment for organizational maintenance of the
Section Il. REPAINTING AND REFINISHING INSTRUCTIONS
prevent covering screw heads, nameplates, and
connectors.
Case, Test Set CY-6785/U is a molded plastic
b. Refer to TB 746-10. Field Instructions for
container which is the same color throughout the
Painting and Preserving Electronic Command
full thickness of the part. For this reason, no
Equipment.
r e p a i n t i n g of the part is required. Touchup
painting should be done only on those areas of the
4-5. Refinishing Exterior Surfaces
test set whose original surfaces had been painted.
You may remove gouges or scratches in the
4-4. Repainting Instructions
p l a s t i c case with fine sandpaper. Sand only
enough to remove rough edges. Do not disrupt
a. Touch up the painted surfaces of the test set
the surrounding finish any more than necessary.
using Olive Drab enamel per FED-STD-595,
Do not attempt to fill in scratches or gouges with
Paint Number X24087, Type 1. Take care to
paint.
Section III. LUBRICATION INSTRUCTIONS
No lubrication is required for Test Set, Radio
Section IV. PREVENTIVE MAINTENANCE CHECKS AND SERVICES
m i n i m u m inspection required. R e c o r d all
deficiencies together with the corrective action as
To ensure that the test set is always ready for
prescribed in TM 38-750.
operation, it must be inspected systematically so
that defects may be discovered and corrected
4-8. Preventive Maintenance Checks and
before they result in serious damage or failure.
Services
The necessary preventive maintenance checks
The preventive maintenance checks and services
applicable to organizational maintenance are
4-1 and 4-2. The item numbers indicate the
s e q u e n c e of items to be inspected and the