b. Replacement of Test Probe cable
-
( 1 ) Insert the probe cable end through
the coupling nut, washer, and
g r o m m e t (a(4) above). (A new
grommet should be used if avail-
able.)
( 2 ) Connect and solder the inner cable
conductor to terminal E7912.
(3) Connect and solder the inner shield
to the ground lug on connector
J7904.
(4) Connect the outer shield to terminal
E7903.
(5) Press the grommet into the box
connector and tighten the coupling
nut.
c. Repair of Cable Assembly, Special
Purpose, Electrical, Branched CX-7899/
VRM-l(fig. 20).
(1) Repairs of the CX-7899/VRM-l
are limited to replacing the 18-
Figure 16. Teat Set, Radio TS-1777/VRM-l front
terminal connector and repairing
p a n e l and chassis. left view.
Figure 17. Test Set, Radio TS-1777/VRM-1 f r o n t panel and chassis, bottom view.
