breaks in the cables near this con-
(3) Reassemble the 18-tertinal con-
nector. Figure 20 is a cable wiring
nector as follows:
diagram and exploded view of the
(a) Place the cables in the grooves
CX-7899/VRM-l.
provided in the connector shell.
(a) Disassemble the 18-terminal con-
(b) Slide the connector clamp over
nector as follows:
the cables and under the female
(a) Remove four screws.
connector.
(b) Remove the connector shell.
(c) Secure the three pieces together
(c) Remove the connector c1amp
and replace and tighten the four
from the female connector.
screws.
Figure 18. Test Set, Radio TS-1777/VRM-1
case
with
f r o n t panel and chassis removed.
31
