TM 11-6625-2632-14
Figure 5-1. Radio Test Set AN/PRM-.2 component identification.
5-6. Troubleshooting Procedures
malfunction to a specific circuit, perform the appropriate
step of the troubleshooting procedure in table 5-3 to
Troubleshooting procedures are intended to isolate the
determine which part needs replacement. Replacement
faulty part when a malfunction has been determined to
exist through operational checks. When the operational
checks of table 5-2 have been performed to localize the
Section III. ADJUSTMENT, ALIGNMENT, REPAIR, REMOVAL, AND REPLACEMENT
5-7. General
Set AN/PRM-32 are grouped together on a panel in the
of the test set. Partial disassembly is required to remove
Adjustment and alignment of the AN/PRM-32 is not
the panel assembly for troubleshooting and repair.
authorized by genera] support maintenance personnel,
Further disassembly may be required if components
must be removed and replaced. The procedures for
Repair is achieved by replacement of defective
removing and replacing those parts which are
components. The electronic components of Radio Test
replaceable are described below.
5-3