TM 11-6625-2632-14
5-9.
Detector Housing Assembly Removal
a. Open the elbow catch (1) and remove two
screws (2).
b. Remove two screws (3) and lift off cover
assembly (4)
c. Pull neoprene gasket (5) off case (6) carefully
b. Remove four screws (1) and lift cover (2) off
and lift panel assembly (7) out of case.
detector housing assembly (3).
CAUTION
Avoid damage to the neoprene gasket
which could prevent its functioning as a
proper seal.
1. Screw
16.
Mounting ring
2. Cover
9. Screw
17.
Test set meter M1
3. Detector housing assembly
10. Panel
18.
Nonrotating lugs
4. Connector J1
11. Screw
19.
Hex nut
5. Hex nut
12. Lockwasher
20.
Connector J2
6. Terminal lug and resistor R2
13. Flat washer
21.
Terminal lug and resistor R1
7. Terminal lug
14. Stepped spacer
21.
Terminal lug and resistor R1
8. Filter capacitor FL1
15. Component board assembly
22.
Receiver wire
Figure 5-3. Radio Test Set AN/PRM-32 detector housing assembly.
5-5